Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
13
Genesis
®
Desking - Modesty Panel
Assembly Instructions
Modesty Panel Installation
(optional)
1. Identify correct length modesty
panel for length of table side (60”
and 48” shown). Radius bends (if
applicable) orient toward corner post
or peninsula post leg (Figure 28).
2. Remove the protective paper backing
on modesty panel felt pads to expose
the adhesive surface. Position a felt
pad centered on the top and bottom
of each modesty panel mounting
bracket face and apply firm pressure
to allow adhesive to set (Figure 28).
2. Rotate mounting brackets at an angle
to fit between panel flanges. Rotate
mounting brackets vertically to lock
in place on panel (Figure 29).
3. Attach assembled modesty panel to
holes on underside of worksurface.
Use two #14 x 1” Phillips screws for
mounting each bracket (Figure 30).
Figure 30
#14 x 1”
Phillips screws
Figure 29
modesty panel
flanges top and
bottom
rotate mounting brackets vertical
to lock in place on panel and
slide to approximate location
on panel
modesty
panel
Figure 28
modesty
panel
felt pads
modesty panel
mounting
bracket
