7
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Monitor Arms - Single Screen Monitor Arm - Model CFS03
Assembly Instructions
Single Screen Monitor Arm
Assembly - Model CFS03
1. If pole assembly mounting systems
have not been installed, reference
“Clamp Mounting Systems”
instructions on page 1 or “Drill
Mounting Systems” instructions on
page 2 before continuing (Figure 1).
2. If monitor mount assembly has
not been installed to the Model
CFS03 extension arm assembly,
reference “Monitor Mount Assembly
to Extension Arm Assembly”
instructions on page 4 before
continuing.
3. Twist the pole cap off the pole
assembly, but save to place back on
pole once all components have been
installed (Figure 1).
4. Slide the support ring down the pole
to the desired height of the monitor
screen. Twist the knob on the support
ring to secure in place (Figure 2).
5. Place the Model CFS03 extension
arm assembly down the pole into
position on top of the support ring
(Figure 3). Tighten the set screw
in the extension arm assembly for
correct tension to pole assembly
(Detail A).
6. Mount the trim ring on top of the
extension arm assembly (Figure 3).
7. Repeat process following steps
1 through 6 above for mounting
additional monitors, then insert the
pole cap on top of the pole assembly
(Figure 3).
Note:
Maximum allowed weight of
monitor screen is 20 lb per monitor
mount.
pole assembly
Figure 1
worksurface
pole cap
mounting system
(clamp mounting
shown)
pole
assembly
support
ring
worksurface
Figure 2
pole assembly
Figure 3
support
ring
worksurface
Model CFS03
extension arm
assembly
trim ring
pole cap
3
/ ”
16
Allen key
monitor
mount
Detail A
3
/ ”
16
Allen key
set
screw
Model CFS03
extension arm assembly
