13
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Monitor Arms - Dual Screen, Two Double Extension Monitor Arms - Model CFS06
Assembly Instructions
pole
assembly
worksurface
pole cap
mounting system
(clamp mounting
shown)
Figure 1
Figure 2
dual hub
support
ring
pole
assembly
worksurface
dual hub arm
assembly
front plate
dual hub arm
assembly
Figure 3
dual hub
support ring
pole
assembly
worksurface
dual hub arm
assembly
pole cap
trim ring
Dual Screen, Two Double
Extension Monitor Arm
Assembly - Model CFS06
1. If pole assembly mounting systems
have not been installed, reference
“Clamp Mounting Systems”
instructions on page 1 or “Drill
Mounting Systems” instructions on
page 2 before continuing (Figure 1).
2. If monitor mount assembly has not
been installed to the dual hub arm
assembly, please reference “Monitor
Mount Assembly to Extension Arm
Assembly” instructions on page 4
before continuing.
3. Twist the pole cap off the pole
assembly, but save to place back on
pole once all components have been
installed (Figure 1).
4. Slide the dual hub support ring
down the pole to the desired height
of the monitor screen. Twist knob on
the support ring to secure in place
(Figure 2).
5. Place the dual hub arm assembly
down the pole into position on top of
the dual hub support ring (Figure 2).
Tighten the set screw in the arm
assembly for correct tension to pole
assembly (Detail A).
6. Mount the trim ring on top of the
dual hub assembly followed by
re-installing the pole cap on top of
the pole assembly (Figure 3).
Note:
Maximum allowed weight of
monitor screen is 20 lb per monitor
mount.
3
/ ”
16
Allen key
set
screw
Detail A
