6
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Barron
®
& Portico™ - Double Flip-Top Table
Assembly Instructions
Cross Tube Assembly
6. With table upright, disengage flip
mechanisms and flip table top up
until it stops (Figure 9).
7. Position cross tube under the
opened table bases as illustrated.
The large holes in the cross tube
should face the floor. Using a
3
/
16
”
hex wrench (Allen wrench) insert
1
/
4
-20 x ½” cap screw into the
large hole in the cross tube, align
and insert the screw in a hole in
the flip base lower plate. From the
top, attach
1
/
4
-20 cap screw to the
nut and screw finger tight to hold
it to plate. Install other screws and
nuts to cross tube and base plates.
Tighten hardware securely
(Detail D).
Handle To Lock Levers Assembly
Note:
Without handle installed it
will take two people to flip table
open.
8. Position a handle over the lock
levers as illustrated, with the rib
side up. Insert a #10-32 screw with
washer into a hole in the handle
and through the bottom hole in a
base lock lever. Attach a #10-32 nut
to the screw finger tight. Insert the
other screw with washer through
the other handle hole and bottom
base lever hole and attach nut.
Using a Phillips screwdriver and
3
/
8
” wrench tighten screws and nuts
securely (Detail C).
9. Grasp table top firmly and lower
into place, press down on top to
lock it into place.
10. Lift up slightly on front edge of
top to ensure it is locked in place.
Apply more downward pressure if it
is not engaged.
11. Table should lock and unlock
easily. Loosening and
re-adjusting the cross tube and
handle may be required to obtain a
smooth operation (Detail D).
handle
cross
tube
#10-32
screw with
washer
lock
lever
#10-32
nut
Detail C
Detail D
Figure 9
1
1
/ -20 x / ”
4
2
cap screws
1
/ -20 nuts
4
