4
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Barron
®
& Portico™ - Flip-Top Table
Assembly Instructions
Flip-Top Table Assembly
Tools Required
• Phillips Screwdriver
Hardware Included for
Flip-Top T-Base
• (12) #14 x 1” Wood Screws
Hardware Included for
Flip-Top X-Base
• (6) #14 x 1” Wood Screws
1. To avoid scratching the table
top, place face down onto a soft
protective surface (Figure 6).
2. Position base assembly on underside
of table top, aligning holes in base
assembly with pre-drilled holes in
table top. Attach using the six
#14 x 1” screws, not to exceed
60 in/lbs of torque. Close flip-top
mechanism by pulling base to a
vertical position. Base is secure
when mechanism “clicks”. Stand
table upright (Figure 6).
Flip-Top Table Operation
For Use
1. Pull top down until mechanism
“clicks” shut (Figure 7).
Figure 6 - Flip-Top Table
flip-top
X-base
#14 x 1”
wood screw
Figure 7
release
tab
For Storage
1. Push down on release tab and lift up
on table top (Figure 7).
Note:
refer to page 7,
Figures 10 & 11 for more
information on flip-top table
operating instructions.