3
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Barron
®
& Portico™ - Lightweight and Short Fold T-Base Folding Table
Assembly Instructions
Lightweight and Short Fold
T-Base Folding Table Operation
To UnFold Table
1. Place table top upside down onto a
soft protective surface (Figure 5).
2. Unsnap table leg from leg holder.
Lift leg to a 90° angle making sure
the base locks securely into place
(Figure 5).
3. Repeat step 2 for other leg.
To Fold Table
4. Place table top upside down onto a
soft protective surface (Figure 5).
5. While depressing either one or both
of the gray release levers on either
side of the leg base, push the leg
down toward the center of the table.
Snap the leg into the plastic leg
holder (Figure 5).
6. Repeat step 5 for other leg.
7. If all four glides do not come
in contact with the floor, adjust
appropriate glide(s) in or out to
stabilize table (Figure 5).
8. While in the folded position, the
spacing bumpers provide protection
for the top surface of an adjacent
table when tables are leaned against
each other (Figure 5).
Caution:
The spacing bumpers
should not be used to stack tables
flat on the floor. Tables are unstable
when stacked in this manner and
could result in personal injury and/or
product damage.
Figure 5 - Lightweight Folding T-Base
release
lever
leg
holder
leg
holder