5
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Barron
®
& Portico™ - Double Flip-Top Table
Assembly Instructions
Double Flip-Top Table Assembly
Tools Required
• Phillips Screwdriver
•
3
/
16
” hex wrench (Allen wrench)
•
3
/
8
” wrench
•
7
/
16
” wrench
Hardware
• Twelve #14 x 1” screws
• Four
1
/
4
-20 x
1
/
2
” Socket Head Cap
Screws with patch
• Four
1
/
4
-20 Nuts
• Two #10-32 x
1
/
2
” Phillip Head
Pan Heads Screws with locking
washer
• Two #10-32 Cap Nuts
Base Installation
1. Unpack table bases and table top.
2. To avoid scratching the table top,
place it finish side down on a soft
protective material.
3. Unlock and open flip base
mechanisms, position base
assemblies on underside of table top,
aligning holes in base assemblies
with pre-drilled holes in table top.
Attach each base to the top using
four #14 x 1” screws in the four front
holes (Figure 8 & Detail A).
4. Close flip-top mechanisms by
pulling base to a vertical position.
Bases are secure when lock level
engages rod (Detail B).
5. Finally, insert and tighten two
#14 x 1” screws to the back of bases,
Insert glides into base feet and stand
table upright (Figure 8).
Note:
Two people are required to
turn table to the up-right position.
Figure 8 - Double Flip-Top Table
#14 x 1”
screw
lock
lever
flip base
mechanism
rod
lock lever
rod
Detail A
lock
lever
rod
Detail B
glide
