62
One Arm Drive (OAD)
NOTE: Some parts are not shown in drawings for better clarity of parts that are being called out.
Installing a New OAD (For converting a Hex OAD to a Blade OAD, skip ahead to Page 63)
1. Remove both wheels from wheelchair.
2. Remove the camber tube assembly. Retain all hardware.
3. Identify which wheel you will be installing the One Arm Drive and base the following instructions on that
wheel/side.
4. Install new axle mounts onto towers with the two M5 socket head cap screws and two M5 nylock nuts
on each side using a 4mm Allen wrench and an 8mm wrench.
NOTE: The clamps on a Rogue are in the standard orientation (as shown below) except when T-
Arms are present, then they are reversed.
5. Install camber tube to axle mounts and tighten M5 socket head cap screws and M5 nylock nuts using
a 4mm Allen wrench and an 8mm wrench. See image below.
Fig. 1
Rogue
Reverse
clamps
when
T-Arms
are
present.
