52
Rogue XP 5th Wheel
Adjusting Spring Force
1. Remove Dynamic 5th wheel assembly from chair.
2. Loosen 6mm screw located on the underside of assembly (Fig. 47:A).
3. To decrease spring rate, slide screw and elastomer away from caster fork assembly. To increase spring
rate, slide screw and elastomer towards caster fork assembly.
4. Retighten 6mm screw (Fig. 47:A). Take care to not overtighten.
Changing or Replacing Elastomer
NOTE: There are two elastomers to choose from - a soft (yellow) and a firm (black). The softer
elastomer (yellow) offers less resistance to the rider so it will move up and down easier when weight
is applied to the system. The firmer elastomer (black) offers more resistance to the rider so it will
not move as much when weight is applied to the system.
1. Remove dynamic 5th wheel assembly from chair.
2. Remove screw (A) using two 4mm Allen wrenches.
3. Using Allen wrench, push threaded barrel (B) out of arm assembly.
4. Slide tubular receiver (C) out of assembly.
5. Remove screw (F) and washer (E) located on the underside of assembly. This will release the elastomer
(D). Remove elastomer and set aside.
6. Insert new elastomer (D) into opening on arm assembly with threaded insert facing down towards slot,
aligned with slot in arm.
7. Thread screw (F) and washer (E) through slot and into threaded insert in elastomer. Retighten screw,
but do not overtighten.
8. Reinsert tubular receiver (C) into arm. Take care to place flat arm of tubular receiver over the top of
elastomer.
9. Align holes on arm and tubular receiver to insert threaded barrel (B) and screw (A).
10. Tighten the two screws (A) with two 4mm Allen wrenches.
A
A
A
C
B
F
D
E
