KGK CCS3000L, Instruction Manual, Page: 4 / 62

4
Introduction
Prohibit
Avoid installing the equipment in a place subject to frequent vibration or
in an unstable place.
Avoid installing the equipment in a place where vibration is directly transmitted to it or in an
unstable place such as a wobbly place. Otherwise, the equipment may fall, causing personal
injury.
Prohibit
Avoid plugging up the vent holes.
Avoid plugging up the vent holes of the equipment. Otherwise, the internal heat does not
dissipate, and the resulting temperature rise may cause fire.
Prohibit
Noisy place
It may be impossible to hear an alarm buzzer sound, etc. Therefore, a response to an
emergency situation may delay.
Prohibit
Place exposed to intense electromagnetic noise from other nearby
equipment
Avoid welding work within 10 m from the equipment. Avoid tying the power cable and other
power lines together in a bundle. Insulate the printhead to avoid direct contact with the conveyor,
etc. Otherwise, a malfunction may occur.
Prohibit
Place in a corrosive gas atmosphere such as acid
Prohibit
Place where ambient temperature and relative humidity are outside the
ranges of 0 to 40
°
C* and 10 to 85% RH (no-condensing) respectively
* 10 to 40
°
C depending on the type of ink
Direction
Be sure to establish a ground.
Establish a Class D ground.
Caution
Prohibit
Place exposed to intense electromagnetic noise from other nearby
equipment
Avoid welding work within 10 m from the equipment.
Otherwise, a malfunction may occur.
Direction
Insulation of the photocell sensor
If the photocell sensor is provided with a metal case, insulate it from the conveyor, etc. using
plastic fittings.
Direction
Insulation of the printhead
Insulate the printhead to avoid direct contact with the conveyor, etc.
Danger