7
Sweep Function
146
Keysight U8903A User’s Guide
Sweep settings
The sweep settings page is shown as follows.
Figure 7-3
Sweep settings page
The sweep parameter selection will vary according to the selected waveform type.
The sweep start and stop points, as well as the step size and number of points,
can only be configured if the Auto Sweep or Manual Sweep mode is selected.
The spot parameter panel will change according to the selected waveform type
and sweep parameter. Refer to
the list of spot parameters.
For the sweep spacing, you may select either linear or log interval. You may also
set the dwell time which represents the delay for each measurement to be taken
during the sweep.
NOTE
– Multitone and arbitrary waveform functions are not applicable in the sweep
mode.
– Amplitude values set on the sweep settings page are assumed to be RMS
values.
Summary of Contents for U8903A
