Keysight U3042AE16, User'S And Service Manual

Page: 58 / 90

U3042AE16 Control Lines
Setting the Control Lines with Address and Data Values
This section describes how to control the rear panel DUT control lines.
The following control feature will function only while the analyzer is in its
Standalone mode.
Setting the Analyzer to Standalone Mode
1. Select Utility > System > Configure > Multiport Capability -OR-
(Instrument > Setup > External Hardware > Multiport > Multiport Configuration...) .
In the dialog box select
Restart as a standalone PNA > OK.
2. Access Interface Control Mode (see page 4 1 )
As described in “Setting the Test Port Paths with Address and Data” on page 4 7 , the
<address>.<data> values are determined in a similar man ne r, with the following exceptions:
• Table 15 will be used.
• The <address> value is always = 112
Table 15 Test Set DUT Control Address and Data Logic Table
<Address> <Data> Description Line/Pin
112 0 ALL DUT Control Lines set to logic high or connected to Pin 13 1-8
112 255 ALL DUT Control Lines set to logic low or connected to Pin 14 1-8
112 1 DUT Control Line 1 set to logic low or connected to Pin 14 1
112 2 DUT Control Line 2 set to logic low or connected to Pin 14 2
112 4 DUT Control Line 3 set to logic low or connected to Pin 14 3
112 8 DUT Control Line 4 set to logic low or connected to Pin 14 4
112 16 DUT Control Line 5 set to logic low or connected to Pin 14 5
112 32 DUT Control Line 6 set to logic low or connected to Pin 14 6
112 64 DUT Control Line 7 set to logic low or connected to Pin 14 7
112 128 DUT Control Line 8 set to logic low or connected to Pin 14 8
54 User's and Service Guide U3042-90012