U3042AE16
Controlling the Test Set with N5222/32/42A/B
Figure 4
2
Command Console for 'B' Model Analyzers
SCPI Command Processor Console
There are two methods in which the PNA-X Command Processor Console can be used to
control the Test Set internal switches to configure the Multiport system for S-Parameter
measurements.
Method 1 - Using GPIB/SCPI Command Values
This method is available while the system is in Multiport mode only.
The Test Set internal switch settings are programmed into the Test
Set firmware; they are configured by the PNA-X S-parameter values.
Method 1 provides more PNA-X control capability than Method 2.
The following example shows two executable commands needed to
create an S-parameter measurement on your Multiport system.
Figure
43
Method 1 - Using GPIB/SCPI Command Values
User's and Service Guide U3042-90012
45
