Keysight M9360A, Service Manual, Page: 28 / 43

Performance Verification Tests
2. Configure the M9360A Soft Front Panel as shown in Table 6 .
Table 6
Parameter Value Notes
RF/LO OUT 1 (Low-band) This setting applies to the RF 1 OUT path.
3. Configure the VNA as shown in Table 7 .
Table 7
Parameter Value Notes
Stop Frequency 2.9 GHz According to the specification of RF 1 OUT.
Measure RF 1 OUT Insertion Loss ≤ 2.9 GHz
1. Take a sweep on the VNA.
2. Select Scale > AutoScale on the VNA.
3. Select
Marker Search
>
Min
(perform min marker search).
4. Record the marker value as the Measured Insertion Loss (≤ 2.9 GHz) of the RF 1 OUT path (use the Test
Report Card – page 41 ).
Measure RF 1 OUT Insertion Loss 2.9 GHz to 26.5 GHz
1. Configure the VNA as shown in
Table 8
.
Table 8
Parameter Value Notes
Start Frequency 2.9 GHz According to the specification of RF 1 OUT.
Stop Frequency 26.5 GHz According to the specification of RF 1 OUT.
2. Take a sweep on the VNA.
3. Select
Scale
>
AutoScale
on the VNA.
4. Select Marker Search > Min (perform min marker search).
5. Record marker value as the Measured Insertion Loss (> 2.9 GHz) of the RF 1 OUT path (use the Test
Report Card – page 41 ).
Measure RF 2 OUT (bypass) Insertion Loss
1. Disconnect the cable from RF 1 OUT on the M9360A, and connect it to RF 2 OUT on the M9360A.
2. Configure the M9360A Soft Front Panel as shown in Table 9 .
Table 9
Parameter Value Notes
RF/LO OUT 2 (High-band) This setting applies to the RF 2 OUT path.
3. Configure the VNA as shown in Table 10 .
Table 10
Parameter Value Notes
Start Frequency 10 MHz According to the specification of RF 2 OUT(bypass).
Stop Frequency 26.5 GHz According to the specification of RF 2 OUT(bypass).
Agilent M9360A PXI Attenuator/Preselector Service Guide 27