Keysight PXI General Purpose Switch Modules Startup Guide
38
General Purpose Module Accessories
Y1182A 200 Pin Shielded Connector Block
This shielded connector block provides a simple method of connecting wires to
Keysight M9131A, M9132A, M9133A PXI switch modules with 200 pin D-Type
front panel connectors. The screw terminals accept wires up to 26AWG and the
connector block has a simple screw clamp for strain relief. The recommended
torque for the screw terminal is 0.12 - 0.15 Nm. PTFE insulated cables are
recommended. The following diagram shows the pinout of the connector block.
The pin numbers match the pin numbers on the switch module’s front panel
connector.
Figure 9
Y1182A 200 Pin Terminal Block Wiring Diagram
Ground
Voltages greater than 30 Vrms, 42Vpk or 60 Vdc present an
electric shock hazard. Disconnect all source voltages
before connecting or removing the source-to-modules I/O
connector or wiring the connector block. All field wiring
must be rated for the highest voltage applied to any single
channel.
