Step 5: Verify Operation of the U5309A Card
Acqiris U5309A Startup Guide
19
1. Configure the RF Generator to produce a Sine signal with a Frequency of 1.0
MHz, an Amplitude of 300 mV rms (+2.55 dBm).
2. Connect the Signal Generator output to the IN 1 connector, and turn on the out-
put.
3. For Windows users, launch the
AqMD3Verify
utility from
Windows Start Menu > Acqiris >
MD3
>
AqMD3Verify
.
A command shell window will open.
Select the instrument PXI address, then
Press any key
to start the test.
4. Check that all the test results are OK.
AqMD3Verify
utility checks the version of the Control FPGA firmware. If
the version is not up-to-date, the tool will automatically propose to update
the firmware using the "Firmware Update Utility". Once the Control
FPGA firmware has been updated successfully, please power off your
computer and restart it again for the update to take effect. You may then
proceed with the
AqMD3Verify
utility as described in this section.
If a Problem is Found
1. Verify that you have made all configuration settings as shown above.
2. Verify that the RF generator is ON and producing the desired signals at the end
of the cable. This can be done with an oscilloscope.
3. Verify that the problem is reproducible.
4. please contact technical support
.
