Keysight Technologies E6650AU-TRX, Installation Note

Page: 4 / 26

4 Installation Note E6650-90013
Introduction
Introduction
The following instructions will guide you through the process of adding and an additional M9440A
TRX module into the E6650A main frame /chassis.
Table of Contents:
— Tools Required
— Remove Face Plate Panel
— Remove New TRX Module Filler Plate from Dress Panel
— Remove Impact Cover
— Remove Module Slot Fillers
— Install the TRX Module and Cable Connections
— Install Impact Cover and Dress Panel
— Enable the New TRX Module (in the XSA configuration file)
— Enable the New TRX Module (by sending a SCPI command)
— Update the FPGA Code
— Back Up New TRX Module Calibration Data to Hard Drive
— Run Self-Test Manual Verify
Tools Required
— T-10 TORX Driver
— T-20 TORX Driver
— #1 Phillip screwdriver
— Needle nose pliers
— Calibration Void if Broken sticker (PN: 7121-5432)
— USB keyboard and mouse
— E6650AU-TRX kit
Optional
— Cable removal tool (PN: 5002-3361)