Keysight Technologies E4982A, Installation Manual

Page: 27 / 62

Installation
1
LCR Meter 25
How to Install the Rack-mount Kit (Option 1CM)
The rack- mount kit includes two flanges (locking side plates)
for mounting the E4982A on a rack (482.6 mm/19 inches)
conforming to the EIA Standard. While referring to
Figure 3 ,
install the rack- mount kit by following these steps.
Step 1.
Remove the adhesive- backed trim strip (1) from
each side of the outer frame of the E4982A front panel.
Step 2.
Use the screws provided to mount a rack- mounting
flange (4) on each side of the E4982A front panel frame.
Step 3.
Remove the four bottom feet of the E4982A (lift the
bar marked TAB on the inner side of the foot and slide the
foot toward the bar).
Step 4.
Mount the E4982A on the rack.
How to Install the Rack-mount and Handle Kit (Option 1CP)
The rack- mount and handle kit includes both the
rack- mounting flanges (locking side plates) and front
handles. While referring to
Figure 3 , install the rack- mount
kit by following these steps.
Step 1.
Remove the adhesive- backed trim strip (1) from
each side of the outer frame of the E4982A front panel.
Step 2.
Use the screws provided to mount a front handle
(2) and rack- mounting flange (4) on each side of the E4982A
front panel frame.
WA R N I N G
If the installed front handle becomes damaged, replace it with a
new one immediately. A damaged handle can break while moving
or lifting the instrument and cause personal injury or damage to
the instrument.
C A U T I O N
Use both a front handle and a rack-mounting flange in the same time
certainly. Do not attempt to install flanges or handles separately
with hardware provided. Serious electrical damage will occur to the
instrument.