Step #3 – CENTER SUPPORT ASSEMBLY – PIVOT WHEEL
REQUIRED PARTS – 2 Sets
INSTRUCTIONS
QTY PART #
DESCRIPTION
1 ea
CENTER SUPPORT ASSEMBLY
(From Step 2)
2 ea #8
WHEEL FOR NON LOCKING
CASTER
1ea #HDW-5 M8X110
BOLT
4 ea #HDW-12
16 MM WASHER
1 ea #HDW-15
M8 BOLT CAP
Slide #HDW-5 (M8x110 BOLT) though #HDW-12
(16MM WASHER), then though #8 (WHEEL FOR
NON LOCKING CASTER), then though another
#HDW-12 (16MM WASHER).
Place CENTER SUPPORT ASSEMBLY from Step 2
with the flange facing away. (Please refer to diagram
above.)
Slide the bolt assembly with the washers and wheel,
through the NON LOCKING WHEEL PIVOT that is
attached to the left hand side of the base of the
CENTER SUPPORT ASSEMBLY.
Slide a #HDW-12 (16MM WASHER), the #8 (WHEEL
FOR NON LOCKING CASTER), and a #HDW-12
(16MM WASHER) onto the #HDW-5 (M8x110
BOLT).
Place the #HDW-15 (M8 BOLT CAP) to the end of the
#HWD-5 (M8x110 BOLT) and twist to secure the
assembly. Tighten the bolt so that it is secure, and yet
the pivot assembly is able to rotate freely.
REPEAT INSTRUCTIONS FOR SECOND ASSEMBLY.
-
12
-
Summary of Contents for K-7122-490
Page 28: ... 28 ...
