Step #8 – CENTER SUPPORT & PIVOT ASSEMBLY
REQUIRED PARTS – 2 Sets
INSTRUCTIONS
QTY PART #
DESCRIPTION
1 ea
CENTER SUPPORT
ASSEMBLY
(From Step 6)
1 ea #PRE-3
CENTER PIVOT ASSEMBLY
(From Step 7)
2 ea #HDW-6
M5x65 BOLT
2 ea #HDW-10
12MM WASHERS
2ea #HDW-18 M6
NUTS
2 ea #HDW-17
M5 NUTS
Position #PRE-3 (CENTER PIVOT ASSEMBLY) with the
bottom two pivot screws facing the support flanges of the
CENTER SUPPORT ASSEMBLY as shown in the above
diagram.
Slide the two pivot screws through the two holes in the
support flanges. Apply the #HDW-18 (M6 NUTS) to the ends
of the pivot screws and tighten to secure.
Slip the #HDW-10 (12MM WASHER) to the two #HDW-6
(M5x65 BOLTS).
Align the holes at the top and bottom of the CENTER
SUPPORT ASSEMBLY to the #PRE-3 (CENTER PIVOT
ASSEMBLY) as shown in the above diagram.
Push the bolts through the two aligning holes in both assembly
parts. Place the #HDW-17 (M5 NUTS) to the end of the
bolts. Tighten the nuts to secure the assembly.
REPEAT INSTRUCTIONS FOR SECOND ASSEMBLY.
-
17
-
Summary of Contents for K-7122-490
Page 28: ... 28 ...
