19
Reattaching the Rower Belt
STEP 1
Begin reattaching the Rower Belt by threading
around the Rower Belt Pulley with the Velcro side
facing upward as illustrated.
Next, thread the Belt around the Idle Wheel as
shown. Once around the Idle Wheel, attach the
Rower Belt to the Belt/Bungee Pulley. There is
an obvious “lip” at the attachment point.
STEP 5
Wind the Rower Belt onto the Belt/Bungee Pulley
until the Rower Handle is as it’s furthest forward
position.
Rethread the Bungee Shock Cord (on opposite
side of the Idle Wheel) back through the Bungee
Pulleys and tie off at the Attachment Point.
Recoil tension will decrease over time as the Bungee Shock
Cord stretches. To increase recoil tension, simply push the
Inner Clip out of the Bungee Hook from behind, pull the required
amount of Bungee through the Inner Clip and replace the Inner
Clip into the Bungee Hook as shown below.
Hint:
Before reattaching the Inner Clip/
Bungee Hook, tie a slip knot under slight
tension at the Lower Bungee Pulley. This
will keep the Bungee under tension while
reassembling the Bungee Hook.
Bungee Hook
Inner Clip
STEP 2
Velcro Facing Upward
Idle Wheel
Rower Handle
Belt/Bungee Pulley
STEP 3
STEP 4
Bungee Shock Cord
Bungee Pulley
