13
Removing/Changing Tank Water
a)
Set Adjuster Knob
to “
1
”
b)
Row at least ten strokes to fill the storage reservoir as
completely as possible.
c)
Remove Tank Plug.
d)
Insert rigid end of siphon into the tank, and flexible hose into a
large bucket.
e) Drain tank (approx. 40% of water will remain) and then refill
following directions for Tank filling as described in the Tank Filling
section of this manual.
Note:
◎
The valve on top of the siphon must be closed to allow proper
drainage.
◎
Water treatment will preclude the need to change tank water if
the treatment schedule is maintained. Additional Water Treat-
ment Tablet is required only when discoloration appears in the
water.
◎
Exposure to full sunlight reduces the life of the Water Treatment
Tablets. Storing the Rower away from direct sunlight will extend
the time between water treatments.
◎
Approximately 40% of tank water will remain. It is not possible to
completely drain the A/R tank without disassembly.
Do not use any water treatment other than the tablets supplied with this unit.
For replacement tablets, contact your local KETTLER distributor.
Water Treatment schedules for the ROWER will vary according to the tanks
exposure to sunlight, but expect 8-12 months near a bright, sunlit window and 2
years or more for a darker location. At the point of finding the water slightly cloudy,
add a Water Treatment Tablet.
Long Term Water Treatment and Basic Operation
CAUTION
It is strongly recommended that a drop cloth be used under the Tank whenever the
Tank Plug is opened for water treatment.
Operation Instructions
Siphon
Tank Plug
How to Adjust Resistance
1. Select your preferred Fluid Resistance.
MINIMUM
MAXIMUM
NOTE: The console level will automatically
reflect the Fluid Resistance
selected at the tank.
When adjusting resistance level, allow two strokes to feel an increase and ten
strokes to feel a decrease.