Kernau KIH 7432-2B, Instructions For Use And Installation, Page: 42 / 84

42
•
The connection to the main must be made using an earthed plug or via an omnipolar circuit breaking
device with a contact opening of at least 3 mm.
•
The electrical circuit must be separated from the network by adapted devices, for example: circuit
breakers, fuses or contactors.
•
If the appliance is not fitted with an accessible plug, disconnecting means must be incorporated in the
fixed installation, in accordance with the installation regulations.
•
The inlet hose must be positioned so that it does not touch any of the hot parts of the hob or even.
CAUTION:
•
This appliance must only be connected to a network 230 V~ 50/60 Hz.
•
Always connect the earth wire.
•
Respect the connection diagram.
•
The connection box is located underneath at the back of the hob casing. To open the cover, use
a medium screwdriver. Place it in the slits and open the cover.
MAINS CONNECTION CABLE DIAMETER CABLE
PROTECTION
CALIBRE
230V~ 50/60Hz 1 Phase + N
3 x 2,5 mm²
H 05 VV - F
H 05 RR - F
25 A *
400V~ 50/60Hz 2 N 4 x 1,5 mm²
H 05 VV - F
H 05 RR - F
16 A *
* calculated with the simultaneous factor following the standard EN 60 335-2-6
CONNECTION OF THE HOB
For the various kinds of connection, use the brass bridges which are in the box next the terminal
Monophase 230V~1P+N
Put the 1st bridge between terminal L1 and L2, the 2nd between N1 and N2.
Attach the earth to the terminal “earth”, the neutral N to terminals N1 or N2, the Phase
L to one of the terminals L1 or L2.
Biphase 400V~2P+N
Put the bridge between terminal N1 and N2.
Attach the earth to the terminal “earth”, the neutral N to terminal N1 or N2, the Phase L1 to the terminal L1
and the Phase L2 to the terminal L2.
CAUTION:
Be careful that the cables are correctly engaged and tightened .
WE CANNOT BE HELD RESPONSIBLE FOR ANY INCIDENT RESULTING FROM
INCORRECT CONNECTION OR WHICH COULD ARISE FROM THE USE OF AN
APPLIANCE WHICH HAS NOT BEEN EARTHED OR HAS BEEN EQUIPPED
WITH A FAULTY EARTH CONNECTION.