Kernau KIH 7432-2B, Instructions For Use And Installation, Page: 39 / 84

39
When the symbol [ E 4 ] appears :
The table must be reconfigured. Please implement the following steps:
I ) Important : before you start, make sure there is no more pot on the hob
II ) Disconnect the appliance from the grid by removing the fuse or turning the circuit breaker off
III ) Reconnect the table to the grid
IV ) Procedure :
•
take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
•
start the procedure within 2 minutes after reconnecting the hob to the grid
•
don’t use the [ ] touch
V
) First step : cancel the existing configuration
1) Press the touch n°2 and hold down
2) The symbol [ - ] will appear on each display
3) With your other hand, press successively and
quickly (less than 2s) on each [ - ] display.
Begin from the front right side and turn contrary clockwise,
as described on the picture (from a to d).
A double "beep" means an error occurred. If so, start again
from item 1).
4) Remove your fingers from the touch control, then
push again on touch 1 during few seconds, until blinking [E]
symbols appear.
5) Wait until [ E ] symbols stop blinking.
6) After few seconds, [ E ] are automatically
transformed in [ C ]. The existing setup has been cancelled.
VI ) Second step : new setup
1) Take a ferromagnetical pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ C ] display
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected cooking zone is now configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.
•
If [ E 4 ] displaying remains, please call the customer care
The control panel displays [ Er03 ]:
•
An object or liquid covers the control keys. The symbol disappears as soon as the key is released or
cleaned.
The control panel displays [ E2 ] or [ E H ]:
•
The hob is overheated, let it cool and then turn it on again.
The control panel displays [ E3 ]:
•
The pot is improper, replace the pot.
The control panel displays [ E5 ]:
•
Faulty power supply. Check the mains voltage.
The control panel displays [ E6 ]:
•
Faulty power supply. Check the mains frequency.