Kernau KIH 7432-2B, Instructions For Use And Installation, Page: 41 / 84

41
8. INSTALLATION INSTRUCTIONS
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
HOW TO STICK THE GASKET
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
His installation has to be done carefully, in conformity of the following drawing.
Stick the gasket (2) two millimetres from the external edge of the
glass, after removing the protection sheet (3).
FITTING – INSTALLING
•
The cut-out sizes are:
TYPE WIDTH DEPTH
KIH 7432-2B 750 mm 490 mm
•
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
•
The hobs are classified as “Y” class for heat protection. Ideally the hob should be installed with plenty
of space on either side. There may be a wall at the rear and tall units or a wall at one side. On the other
side, however, no unit or divider must stand higher than the hob.
•
The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture,
the laminate coatings and the glue used to fix them, must be able to resist temperatures of up to 100°C.
•
Do not install the hob at the top of a non ventilated oven or a dishwasher.
•
Ensure under the bottom of the hob casing a space of 20 mm to ensure good air circulation of the
electronic device.
•
If a drawer is placed under the hob, avoid putting into this drawer flammable objects (for example:
sprays) or non heat-resistant objects.
•
Materials which are often used to make worktops expand on contact with water. To protect the cut-out
edge, apply a coat of varnish or special sealant. Particular care must be taken when applying the
adhesive joint supplied with the hob to prevent any leakage into the supporting furniture. This gasket
ensures a good seal when used in conjunction with smooth work top surfaces.
•
The safety gap between the hob and the cooker hood placed above must comply with the
recommendations of the hood manufacturer. In the case of no instructions, a distance of 760 mm
minimum should apply.
•
The connection cord should not be subjected to any mechanical constraint.
WARNING
:
Use only hob guards designed by the manufacturer of the cooking appliance or indicated by the manufacturer
of the appliance in the instructions for use as suitable or hob guards incorporated in the appliance. The use of
inappropriate guards can cause accidents.
ELECTRICAL CONNECTION
•
The installation of this appliance and the connection to the electrical network should be entrusted only
to an electrician perfectly to the fact of the normative regulations and which respects them
scrupulously.
•
Protection against the parts under tension must be ensured after the building-in.
•
The data of connection necessary are on the stickers place on the hob casing near the connection box.