18
4 .3 .1 Shearing drive
Does not require lubrication.
4 .3 .2 Flexible shaft
Before each operation
Oil the flexible shaft before each use, but at least once when changing the blade.
After 100 hours of operation
The flexible shaft is equipped with sealed and permanently lubricated ball bearings. However, the rotating inner shaft must be re-greased at
regular intervals (after approx. 100 operating hours or every 2 years). To do this, disassemble the outer shaft to first remove the old grease
residues from the inner shaft. Then grease the entire length of the inner shaft again with fresh, high-quality mineral grease.
4 .3 .3 Shearing handle
See the operating instructions for the shearing handle.
4 .4 Storing the machine
Make it a habit to always keep the shearing equipment well cleaned between uses, in a dry and clean place, out of the reach of children.
5 Faults and repairs
5 .1 Introduction
Measures to rectify faults are marked in the "Remedy" column of the fault list. In the event of a malfunction not covered in this manual,
contact an authorised service centre.
5 .2 Fault list
Fault
Cause
Remedy
Motor not running.
No power.
Check the cable and fuse.
Cable faulty.
Have the cable replaced.
Switch faulty.
Have the switch replaced.
Motor faulty.
Have the motor replaced.
Capacitors faulty.
Have the capacitors replaced.
Motor always switches off.
Blades blocked.
Remove the blockage.
Mechanical damage in the shearing handle
or in the outer shaft.
For troubleshooting, first uncouple the
shearing handle and restart the system. If
the fault still occurs, uncouple the outer
shaft from the shearing drive. Repair the
damage.
If the fault still exists, have the shearing
drive repaired.
Power supply too weak.
Check the power supply.
Shearing equipment makes noise or
vibrates.
Motor bearing faulty.
Have the motor replaced.
Motor gets warm.
Motor bearing faulty.
Have the motor replaced.
Malfunctions on the outer shaft and/or
shearing handle.
Have the fault corrected.
Shearing drive cannot be switched off.
Switch faulty.
Have the switch replaced.
