KEPCO ATE 100-10DMG, Operator'S Manual, Page: 96 / 98

B-22
ATE-DMG 020613
B.91 SYSTem:PASSword:CENable COMMAND
SYST:PASS:CEN
Syntax : Short Form: SYST:PASS:CEN <val> Long Form: SYSTem:PASSword:CENable <val>
Description: Sets the password enable state if the value matches the current password. This command allows
other commands such as *SAV 41 to operate.
B.92 SYSTem:PASSword:CDISable COMMAND
SYST:PASS:CDIS
Syntax : Short Form: SYST:PASS:CDIS <val> Long Form: SYSTem:PASSword:CDISable <val>
Description: Clears the password enable state if the value matches the current password.
B.93 SYSTem:PASSword:STATe? QUERY
SYST:PASS:STAT?
Syntax : Short Form: SYST:PASS:STAT? Long Form: SYSTem:PASSword:STATe?
Return Value: <int_value> 0 or 1
Description: Returns a 1 if the password state is enabled or a 0 if it is disabled.
B.94 SYSTem:SECurity:IMMediate COMMAND
SYST:SEC:IMM
Syntax : Short Form: SYST:SEC:IMM Long Form: SYSTem:SECurity:IMMediate
Description: Initializes all NVRAM variable to factory defaults. This includes all memory steps to be set to 0 volts,
1.28% of full scale current, overvoltage and overcurrent to be set to Iomax+10%, time value to be set
to 0, and next step equal to 0.).It also initializes the power -up state to have DC Output Control off (see
DCL Control, PAR 3.5.2). The calibration password is reset per Table 4-2 Use master password (see
below) If password has been lost. Related Commands: SYST:PASS:CEN must be sent prior to this
command
TABLE B-5. MASTER PASSWORDS
MODEL PASSWORD MODEL PASSWORD MODEL PASSWORD
ATE 6-
100DMG
..17
ATE 36-
30DM
..44
ATE 100-
10DMG
..78
ATE 15-
50DMG
..26
ATE 55-
20DMG
..52
ATE 150-
7DMG
..86
ATE 25-
40DMG
..35
ATE 75-
15DMG
..69