KEPCO ATE 100-10DMG, Operator'S Manual

Page: 27 / 98

ATE-DMG 020613
2-3
FIGURE 2-2. ATE-DMG FULL RACK SERIES REAR PANEL
TABLE 2-2. REAR PANEL TERMINATIONS
FIGURE 2-2
INDEX NO.
TERMINATION FUNCTION
1 GPIB (IEEE 488) Interface
connector Allows digital control of power supply and provides digital indication of status and
power supply output. See Table 2-4 for input/output pin assignments.
2 Interconnection Assembly Used to gain access to internal circuitry for fast mode conversion, troubleshooting,
and parallel/serial connections. Can also be used with PC-12 connector (wired) for
troubleshooting.
3 Rear Panel Barrier Strip Nine terminals provided:
1, 7: Co (–) and Co (+) used to connect external output capacitor.
2, 6: S (–) and S (+) used to connect external sensing leads.
3, 5: M (–) and (+) used for output monitor connections.
4: Ground
8, 9: Used to connect or disconnect internal grounding network (see PAR. 2.6.1.2)
4 Output terminals Used to connect load
5 Source power terminal
block Used to connect source power; accepts 3-wire a-c input cord (supplied).