KEP ES-756, Installation & Operating Instructions Manual

Page: 15 / 22

11
PRESS DISPLAY REMARKS
input
RELAYS
A RATE, A ToT
or
A PUL
(IF TOT or PUL
SE LECTED)
DuR A
(hit any key to view or
change ex ist ing dur A
value XX.X)
(IF RATE SELECTED)
HYS A
(hit any key to view or
change ex ist ing HyS A
value XXXXX)
B RATE
,
B ToT
or
b PUL
(IF TOT or PUL
SE LECTED)
DuR B
(IF RATE SELECTED)
HYS B
STEP
2
SET TING
RELAYS
NOTE: If out puts are
not used, set
dur A & dur
B at "0.00" to
pre vent the
counters from
re set ting at
the presets.
This section of the menu sets up the
open collector outputs.
Output A assigned to the rate,total or
pulse output. Press the PRGM key
to toggle be tween choices, press the
RST/ENTER key to enter the displayed
choice.
dur A = the duration of time (0.01 to
599.99 sec) that output A will remain on
or energized. When dur A is dis played,
hit any key to view or change dur A.
Press the RST/ENTER key to enter
dis played value. When dur A is set at
0.00,output A will latch until re set; when
dur A is set other than 0.00 the counter
will au tore cycle at Preset A.
Hys (hysteresis)= The number of units
below the preset that the output will
remain "ON". EXAMPLE: Preset set
@ 100; HyS set @ 10. Output will
activate (turn on) when rate = 100 and
turn off when rate falls below 90 (10
below preset).
Follow instructions for A RATE, A TOT
& A PUL
Follow instructions for dur A
Follow instructions for hys A
PRGM
PRGM
ENTER
ENTER
ENTER
ENTER
ENTER PRGM
ENTER PRGM