Kenwood X-W320, Instruction Manual

Page: 11 / 37

X-W 3 2 0 (En)
1 1
Preparation for playback (recording)
POWER
-
ON
–
OFF
Before playback (recording)
Set the POWER sw itch to ON.
: Keys and control used in the operations described on this page.
Load a cassette tape in deck A or B.
Determine the playback (recording) condition.
Select the tape transport direction.
3
2
2
Press the 7 key.
2
3 7
Normal position TYPE
High position TYPE
2
Insert a tape and close the cassette holder.
Deck B:
Playback/
recording
available.
B A
Playback (recording) preparation
1
2
3 7
1
Press the
2
key or
3
key.
1
Select the playback (recording) mode.
REV.
MODE
To play (record) tape side A.
÷
Be sure to remove tape slack before insertion.
÷
The type of tape, that is, the Normal or High position is selected
automatically.
÷
This unit cannot record sound on a M etal tape.
÷
Be sure to close the cassette holder securely by pushing it.
÷
Feed the tape section w hich cannot be played
or recorded onto in the forw ard direction.
÷
Select the Dolby NR mode according to the tape recording status.
Deck A:
Playback
only.
To play (record) tape
side B.
The
2
and
3
indicators show the direction the tape is transported
during recording or playback. The direction used w hen the tape is
last stopped is held in memory even after this unit has been turned
OFF, and the tape transport starts in the indicated direction w hen
the unit is started automatically by a timer, etc. To change the tape
transport direction, press the play key for the opposite direction and
immediately press the
7
key.
Tape transport direction indicators
A B
B C DOLBY NR
STANDBY
COUNTER
DUBB. NOR. HIGH (SP) CCRS
O.T.E.
R
20 3 3 6 (dB) 6 10 15 0
L
0 0 0 0
Deck B direction indicators. Deck A direction indicators.
Each press sw itches the indication.
1
“
[
” :Double-side playback (recording) w hich stops tape stops
after having played (or recorded) both sides.
2
“
”
” :Playback is endless, but recording stops after having
recorded both sides.
3
“
“
” :One-w ay playback (recording) w hich stops tape after
having played (or recorded) a single side.
Each press sw itches the indication.
1
DOLBY NR “ OFF” (extinguished): Dolby NR is not used.
2
DOLBY NR “ B” : Noise reduction of the ordinary type.
3
DOLBY NR “ C” : Noise reduction w ith higher performance.
2
Select the Dolby NR mode.
DOLBY NR
0
1
Press the
0
button.
Downloaded from: http://www.usersmanualguide.com/