Kenwood TKR-750, Programming Reference Manual

Page: 49 / 83

Version: 1.01 Field Programming Reference (FPRG) 44
6 EDIT MENU
Table 6-5 The Transmitting channel during Scan.
Note:
!
The Transpond code is sent while the scan operation is
pausing.
!
The Transpond code is sent on the Revert CH when the
Scan operation is switched On by the Air Remote.
6.9.1 PF Key Tab
On this tab, It can configure the Air Remote code
assigned to PF keys controlled.
Figure 6-17 “PF Key” tab
"
Function (PF Key)
The function configured on the “Key Assignment”
window appears. However, you cannot change the
configuration on this window.
(Refer to 6.5 Key
Assignment Window.)
"
Activation (PF Key)
This is a standby Air Remote code to be decoded in
order to activate the assigned function for the PF key.
From the dropdown list, you can select a table number
in the “Decode” tab from “Encode/Decode” table
window.
(Refer to 6.8 “Encode/Decode Table”
Window.)
Note:
!
You cannot configure the “Activation” if no function is assign
to “Function”.
(Refer to
"
Function (PF Key).)
!
When Dec. Table is already used in other functions, you
cannot configure the same Dec. Table.
"
Deactivation (PF Key)
This is a standby Air Remote code to be decoded in
order to deactivate the assigned function for the PF
key. From the dropdown list, you can select a table
number in the “Decode” tab from “Encode/Decode”
table window.
(Refer to 6.8 “Encode/Decode Table”
Window.)
Note:
!
You cannot configure “Deactivation” if no function is assign
to “Function”.
(Refer to
"
Function (PF Key).)
!
You cannot configure “Deactivation” to the functions that it
cannot be disable, such as Channel Up function.
!
When Dec. Table is already used to other functions, you
cannot configure the same Dec. Table.
"
Transponder (PF Key)
This is a timing to send the Transpond code. Select
one of “None”, “Fore”, “After” and “Both” from the
dropdown list.
Note:
!
You cannot configure “Transponder” if no function is assign
to “Function”.
(Refer to
"
Function (PF Key).)
!
You may not be allowed to select “After” or “Both” due to the
assigned functions to the PF key. (Example: Reset, CW ID
On)
(Refer to 6.5 Key Assignment Window.)
Transmission event During the Scan
While the Scan
pauses.
AUX In & In (I/O) Revert CH Revert CH
AUX Out Revert CH
CH that Scan
pauses
Air Remote Transpond -
CH that Scan
pauses
Range None, Dec. Table 1 - 40
Default None
Range None, Dec. Table 1 - 40
Default None
Range
None Not send the Transpond code.
Fore
Sends the Transpond code when
receiving the Air Remote code.
After
Sends the Transpond code after
processing the received Air Remote code.
Both
Sends the Transpond code when
receiving the Air Remote code and after
processing the received code.
Default None