Field Programming Reference (FPRG)
42
6 EDIT MENU
6.8
“Encode/Decode Table”
Window
It can configure the DTMF Encode/Decode code and the
function relating to the Transpond function. You can
configure this function when the DTMF signalling is used.
This window consists of “Encode” and “Decode” tabs and
you can switch the window by clicking the tabs.
Figure 6-15 Encode tab
Figure 6-16 Decode tab
6.8.1
Encode Code
It can configure the Encode code with a maximum of 16
digits of the DTMF Tone. Enter the code in the edit boxes
from No. 1 to No. 32.
6.8.2
Frequency
This is a frequency to transmit Single tone as the
Transpond code when the function assigned to the PF
key or the auxiliary port activates/deactivates. You can
configure the frequency for both of “Activation” and
“Deactivation”. Configure the frequency by the spin
buttons or directly enter the value to configure the
frequency.
6.8.3
Period
This is a period to transmit Single Tone as the Transpond
code when the function assigned to a PF key or an
Auxiliary port activates/deactivates. You can configure the
transmission period for both of “Activation” and
“Deactivation”. Configure the period by the spin buttons
or directly enter the value to configure the period.
6.8.4
Sidetone
It allows to transmit a sidetone when sending the DTMF
code. This function is used to feedback the audio tone to
the transceiver's speaker.
Note:
You cannot transmit the sidetone when the “Operation
Mode” is configured as “Simplex”.
6.8.5
Decode Code
Range
16 digits
0 - 9, A - D, *, #
Default
No. 1 is 159D.
No. 2 - No. 32 are blank.
Range
100 - 3000 Hz
In steps of
10 Hz
Default
800 Hz (Activation)
600 Hz (Deactivation)
Range
100 - 3000 ms
In steps of
50 ms
Default
1000 ms (Activation)
2000 ms (Deactivation)
Range
Checked
Transmits the sidetone with DTMF
code.
Unchecked
Not transmit the sidetone with the
DTMF code.
Default
Checked
Summary of Contents for TKR-750
Page 2: ......
Page 64: ...6 EDIT MENU 59 Field Programming Reference FPRG Version 1 01 ...
Page 79: ......
Page 83: ......