Kenwood TK-782, Service Manual, Page: 20 / 91

19
TK-782
"
Other Functions
!
Manual Dial
Fleet, ID and Status numbers can be entered from DTMF
keypad. (DTMF microphopne is required.)
!
Data TX with QT/DQT
Whether programmed QT/DQT is modulated or not with a
data transmission except for Selcall. A radio unit can receive
a data message regardless of QT/DQT if the receiving unit is
not scanning.
!
DMS Baud Rate
FFSK data baud rate setting. The same rate must be set
as a communication partner.
1200bps :
Data communication is made in 1200bps. The communi-
cation area is much wider than 2400bps. Recommended
for repeater operation.
2400bps :
Data communication is made in 2400bps. The communi-
cation area is narrower than 1200bps, but it will decrease
the data traffic. Data rate 2400bps may not work properly
depending on the repeater’s characteristic.
!
Inter-Fleet Call
Inter-fleet calls allow a radio of one fleet number to call a
radio with a different fleet number (radio users can manually
dial a unit ID with a different fleet number).
!
Status/Short/Long Message on Data Group/Channel
Status/Short/Long Message transmission is made whether
on the Data Group/Channel.
!
Status/Short/Unit ID Message Serial Output
Whether a received Status/Short message or PTT ID is
outputed or not to serial port.
"
GPS Report
A NMEA-0183 GPS unit must be installed.
!
GPS Report Mode
GPS data can be sent automatically or upon request. Manu-
ally sending GPS data works regardless of this setting.
Auto : GPS data is sent both automatically and by re-
quest. GPS Auto TX Interval and GPS Time Mark must be
adjusted if required.
Poll : GPS data is sent upon request from dispatcher.
!
GPS Report Interval
Interval time between automatic GPS data transmissions.
!
GPS Time Mark (Per Mobile)
The amount of time from the 0 (zero) minute of the stan-
dardized GPS UTC time to starting the first transmission of
GPS data. It must be set to a different value for each radio
unit to avoid a transmission crash.
OPERATING FEATURES /
"
!
!
!
!
!
!
"
!
!
!