1-18 (No.RA077<Rev.001>)
3.2
Precautions for Reassembly
(1) Attach Rubber Sheet & Cushion to the chassis.
(2) Attach Terminal (-) with Cushion to the chassis.
(3) Attach the Knob and other parts to the Volume/ Selector as
shown.
Note:
Jig for Circular Nut (Part No.: W05-1012-00)
(4) Attaching the Battery Release Lever to the Front Case
• Insert one side of the shaft into the hole at the lever fitting
section on the Front Case.<1>
Note:
The thin spring should be positioned above the two
tabs of the lever.
• Tilt the battery release lever slightly forward <2>, so that
the thick spring is positioned below the case surface.
• With the thick spring positioned below the Front Case
surface, attach the other side of the shaft to the Front
Case by pressing the battery release lever <3> until it
snaps into place <4>.
Note:
Be careful not to tilt the battery release lever too
forward.
If the battery release lever is pushed in this state
where the two tabs come below the Front Case
surface, there is a possibility of damaging the two
tabs.
Battery Release Lever is completely fixed when the
chassis is assembled to the Front Case.
Cushion
Cushion
Rubber Sheet
Terminal (-)
Cushion
Circular Nut
Knob
Volume
Selector
Washer
Rubber Seal
<1>
<2>
A thin spring
Shaft
Tow tabs
A thick spring
<3>
<4>
