1-6 (No.RA077<Rev.001>)
2.2
REALIGNMENT
2.2.1 Modes
2.2.2 How to Enter Each Mode
2.2.3 PC mode
2.2.3.1
Preface
The transceiver is programmed by using a personal computer
(PC), a USB programming cable (KPG-22U) and a Programming
software (FPU).
The programming software can be used with a PC. Fig.1 shows
the setup of a PC for programming.
Fig.1
2.2.3.2
Connection procedure
(1) Connects the transceiver to the PC using the KPG-22U.
Note:
You must install the KPG-22U driver in the PC to use
the KPG-22U.
(2) When the POWER is switched on, you can immediately
enter user mode.
When PC sends command the transceiver enter PC mode.
When data transmitting from the transceiver, the red LED
lights.
When data receiving to the transceiver, the green LED
lights.
2.2.3.3
KPG-22U description (USB programming interface
cable: Option)
The KPG-22U is a cable which connects to a USB port on a PC.
When using the KPG-22U, install the supplied CD (with driver
software) in the PC.
The KPG-22U driver runs under Windows 7, 8.1, 10.
The latest version of the USB driver is available for download
from the following URL:
https://www.kenwood.com/usb-com/
(This URL may change without notice.)
Mode
Function
User mode
For normal use.
PC mode
Used for communication between the
transceiver and PC.
PC programming
mode
Used to read and write frequency data and
other features to and from the transceiver.
PC test mode
Used to check the transceiver using the
PC. This feature is included in the FPU.
PC tuning mode
Used to tune the transceiver using the PC.
Clone mode
Used to transfer programming data from
one transceiver to another.
Mode
Operation
User mode
Power ON
PC mode
Received commands from PC
Clone mode
[Side 2] + Power ON (Two seconds)
User mode
PC programming mode
PC test mode
PC tuning mode
PC mode
Clone mode
PC
KPG-22U
FPU
Tuning cable
(W3F-0381-00)
MIC –
MIC +
SP –
SP +
