NX-800
7
3.
•
How to enter the password with the microphone keypad;
If you press a key while “CLONE LOCK” is displayed, the
number that was pressed is displayed on the transceiver.
Each press of the key shifts the display in order to the left.
When you enter the password and press the [
*
] key,
“CLONE MODE” is displayed if the entered password is
correct. If the password is incorrect, “CLONE LOCK” is
redisplayed.
•
How to enter the password with the [
] and [
] keys;
If the [
] and [
] keys is pressed while “CLONE LOCK”
is displayed, number (0 to 9) are displayd flashing. When
you press the [ ] key, the currently selected number is
determined. If you press the [ ] key after enterning the
password in this procedure, “CLONE MODE” is displayed
if the entered password is correct. If the password is in-
correct, “CLONE LOCK” is redisplayed.
4. Power on the slave transceiver.
5. Connect the cloning cable (Part No. E30-3382-05) to the
modular microphone jacks on the master and slave.
6. Press the [ ] key on the master while the master dis-
plays “CLONE MODE” The data of the master is sent to
the slave. While the slave is receiving the data, “PRO-
GRAM” is displayed. When cloning of data is completed,
the master displays “END”, and the slave automatically
operates in the User mode. The slave can then be oper-
ated by the same program as the master.
7. The other slave can be continuously cloned. When the
[
] key on the master is pressed while the master
displays “END”, the master displays “CLONE MODE”
Carry out the operation in step 4 to 6. Can not be cloned if
the overwrite password is programmed to the slave.
Note:
Only the same models can be cloned together.
REALIGNMENT
Cloning cable
(E30-3382-05)
Fig. 2
8. Firmware Version Information
Turn the transceiver ON with the [
] key held down.
Then, the version is displayed during holding the [
] key.
