42
KVT-719DVD/729DVD
/729DVDY/739DVD
correction / Mechanism position adjustment / DC Offset
infor mation / Memor y infor mation / Retailer mode
information / Service information
Note:
Since the above data is cleared (not defi ned) when
the E2PROM has been replaced during the service, it is
required to re-adjust the data in the test mode.
2-4-17. Security Code writing-in
• To write-in the Security Code (for other destinations than
K/R) maintained in pair with the serial number, call out the
Security screen from the Setup screen with the [Security
Set Up] key.
• When E2PROM’s Secur ity Code is blank in other
destinations than K/R, Set key is displayed. Press the Set
key.
• In the Security Code writing-in screen, run the same
operation as when registering Security Code in normal
mode, and press [Enter] key to start writing.
Note:
The Security Code to be entered here is a set-
specifi c code linked to the serial No.
• If “Complete” is displayed, operation was completed
nor mally, and if “NG” is displayed, operation was
completed with errors.
Note:
If NG, go to the test mode again and repeat from
the 1st step.
●
Procedure to clear Security Code
• If the unit is started with the Security ON condition when
the destination is K/R, use the following procedure to
clear the Security Code (in the mode other than the test
mode).
q
When unit is Reset or is switched on after backup is
OFF, with the condition that Security is ON, unit boots
up from the Security Code Entry screen.
w
Manually enter the code from the remote controller
following the next procedure where the AudioSW
mode has to be selected on the accessory (remote
controller).
Step 1: “K” input (Press Tenkey5 2 times)
Step 2: “C” input (Press Tenkey2 3 times)
Step 3: “A” input (Press Tenkey2 once)
Step 4: “Q” input (Press Tenkey7 2 times)
Note:
On the other remote controller than that
provided as an accessory, pressing Tenkey7 2 times
enters “R” in the unit.
When entry is made improperly during the Steps 1~4,
repeat code entry from Step 1 after entering another
remote controller Key.
w
When the Security Code input screen is cleared,
clearing of the SecurityCode is complete.
2-4-18. Other
• Do not operate the Back Up Memory function in the test
mode.
TEST MODE
