13
KIV-700/BT900
y
Only in E type, switch frequency to LW-216kHz by pressing [2] key or [FAV] key brie
fl
y in TUNER AM band.
y
In the model for all destinations, switch Band by pressing [SEARCH MODE] key brie
fl
y in TUNER source.
FM1
→
FM2
→
(FM3)
→
AM
→
(AM2)
→
FM1…
∗
Except for the model KIV-BT900, the above sequence of changes is the same as the sequence in the normal mode.
TUNER setting adjustment mode operation procedure
1. Select Band by pressing [SEARCH MODE] key brie
fl
y.
2. Transfer to TUNER setting mode by pressing and holding [
] key for 2 seconds. At the same time, set up FM receive fre-
quency to 97.9MHz.
3. Switch the adjustment mode with [SEARCH MODE] key.
Soft Mute adjustment
[SEARCH MODE]
key
[SEARCH MODE]
key
[SEARCH MODE]
key
Seek Stop Leve adjustment
(Manual)
Seek Stop Level adjustment
(Automatic)
4. Use the following adjustment method for every adjustment item.
Soft mute adjustment mode
• Image of display
S M D – x _ _ _
(In the “x”, the adjustment value, 0~F (07FST), 0~7 (08FST) is displayed.)
• Operation procedure
1)
Press key, [
] or [
] to adjust the value between 0 (18dB
μ
) through F (07FST) and 7 (08FST) (You can keep pressing the
key to adjust the value).
2)
After setting up the adjustment value, press and hold [AUD] key for 2 seconds to write the value in E2PROM. After the suc-
cessful completion of writing the value in E2PROM, “EP_WRITE” shall be displayed.
•
Restrictions
This function is operational only in TUNER FM.
Make adjustment by setting 30 in the VOLUME setting and by setting OFF in the Audio related adjustment value.
Seek stop level automatic adjustment mode
• Image of display
(In the case of Normal [Local OFF])
A T N _ 4 . 3 2 V
A T L _ 3 . 4 5 V
(In the case of Local [Local ON])
The
present
reception
level
is
displayed.
• Operation procedure
1)
In the band in which Local Seek ON/OFF switching is allowed, press [TEL] or [TI] or [PLAY MODE] key brie
fl
y to switch on
or off the Local Seek (Local Seek ON/OFF).
2)
Press and hold [AUD] key for 2 seconds to write the present reception level in E2PROM as the seek stop level. After the
successful completion of writing the level in E2PROM, “EP_WRITE” shall be displayed.
∗
At time moment, use Local Seek ON/OFF to change where to write in the level (Destination of the writing-in).
(Note)
The adjustment shall be started with Soft
Mute adjustment.
However, since no Soft Mute adjustment is
required in AM band, the adjustment shall be
started with Seek Stop Level adjustment (Au-
tomatic).
TEST MODE
