16
KIV-700/BT900
■
Menu list adjust mode
y
Press [MENU] key brie
fl
y to display the Menu list.
y
Press [DNPP/SBF] and [DIRECT] key on the remote controller to transfer into the Menu list mode.
y
You shall not use the remote controller to successively send the items.
y
Only in the Test mode, add “Phone Selection” in Menu list display when the source is STANDBY, and it is located as the de-
fault item (head of the list). (Only in the model with the built-in BT)
y
In Tuner (FM) source, the Local Seek shall be the
fi
rst item. (Only for E destination)
■
Backup current measurement
When the unit is reset when it is in ACC OFF (BackUp ON) condition, MUTE terminal is not turned off in 15 seconds but in 2
seconds.
■
DC offset error detection information clear (E2PROM data clear)
While keeping pressing [SRC] and [
] keys, reset and turn on the unit to enter the DC offset error display mode.
(While “– – – –” is being displayed, power can be ON for 30 minutes.)
In the display during STANDBY source, the present DC offset error detection condition is displayed.
1st row
DC offset error detection display 1 (Information to indicate if there is a misconnection or other detection or not)
(Display)
D C 1 _ O K _ _
(Not detected yet)
E R R (A
misconnection or other detection)
2nd row
DC offset error detection display 2 (Number of capacitor leak detected)
(Display)
D C 2 _ 0 _ _ _
(Not detected yet)
1 _ _ _
(Leak detected once)
2 _ _ _
(Leak detected 2 times)
3 _ _ _
(Leak detected 3 times)
4 _ _ _
(Leak detected 4 times or more)
■
Channel space switching (Only for models of destination “K” and “M”)
While keeping pressing [AUD] and [DISP] keys during POWER OFF, press [SRC] key to turn the unit on.
FM200kHz/AM10kHz
↔
FM50kHz/AM9kHz
■
Security (Only for European model)
Forced POWER ON mode
Even if “_ _ _ _” is being displayed, it is possible to turn on the power (POWER ON) only for 30 minutes by resetting the product
while pressing [SRC] and [TI] keys. After 30 minutes have elapsed, the set can be recovered only by resetting it.
How to clear the security code
1. While “_ _ _ _” is being displayed, press [
] key for 3 seconds or longer while pressing the [TI] key. (This makes the “_ _ _ _”
display disappear.)
2. Input “KCAR”, using the remote controller.
Press [5] key of the remote controller 2 times (Input for “K”) and press [
] key.
Press [2] key of the remote controller 3 times (Input for “C”) and press [
] key.
Press [2] key of the remote controller once (Input for “A”) and press [
] key.
Press [7] key of the remote controller 2 times (Input for “R”) and press [
] key.
3. The security is cleared and the unit enters STANDBY mode.
4. If wrong codes are input, “_ _ _ _” will be displayed again.
TEST MODE
