9
EN
M ake connections as show n in the follow ing pages.
When connecting the related system components, be sure
t o refer t o t he inst ruct ion m anuals supplied w it h t he
components you are connecting.
Do not connect the pow er cord to a w all outlet until all
connections are completed.
Note
Be sure to insert all connection cords securely. If their connections
are imperfect, sound may not be produced or there w ill be noise infer-
ence.
Analog connections
Audio connections are made using RCA pin cords. These cables transfer
stereo audio signal in an “ analog” form. This means the audio signal
corresponds to the actual audio of tw o channels. These cables usually
have 2 plugs on each end, one red for the right channel and one w hite for
the left channel. These cables are usually packed together w ith the
source unit, or are available at your local electronics retailer.
M icrocomputer malfunction
If operation is not possible or an erroneous display appears, even
t hough all connect ions have been m ade properly, reset t he
microcomputer referring to “ In case of difficulty” .
›
CAUTION
Be sure to adhere to the follow ing, or proper ventilation w ill be
blocked causing damage or fire hazard.
• Do not place any objects impairing heat radiation onto the top of the
unit.
• Leave some space around the unit (from the largest outside dimen-
sion including projection) equal to or greater than, show n below .
Top panel : 50 cm
Side panel : 10 cm
Back panel : 10 cm
Setting up the system
Input mode settings
DVD/ CD, VIDEO 2 and FRONT AUX inputs each include jacks for
digital audio input and analog audio input.
The initial factory settings for audio signal playback for DVD/ CD,
VIDEO 2 and FRONT AUX.
After completing connections and turning on the amplifier, follow the
steps below .
1
Use the Input Selector keys to select DVD/ CD, VIDEO 2 or
FRONT AUX.
2
Press the INPUT M ODE key.
Each press sw itches the setting as follow s:
In DVD/ CD, VIDEO 2 or FRONT AUX play mode
1
FULL AUTO (digital input, analog input)
2
D.M ANUAL (digital input)
3
ANALOG (analog input)
In DTS play mode
1
FULL AUTO (digital input, analog input)
2
D.M ANUAL (digital input)
Digital input:
Select this setting to play digital signals from a DVD, CD, or LD
player.
Analog input:
Select this setting to play analog signals from a cassette deck, VCR,
or record player.
Auto detect:
In “
FULL AUTO” m ode (FULL AUTO displayed), the am plifier
detects the digital or analog input signals automatically. Priority is
given to digital signal during input mode selection. The receiver w ill
select the input m ode and listening m ode autom atically during
playback to match the type of input signal (Dolby Digital, PCM , DTS)
and the speaker setting. The
DIGITAL indicator on the display w ill
light up w hen digital signal is detected during
FULL AUTO mode or
during
D.M ANUAL mode. If the input signal is analog, the DIGITAL
indicator w ill go off.
To keep the amplifier set to the currently selected listening mode,
use the
INPUT M ODE key to select “ D.M ANUAL” (manual sound).
How ever, even w hen this setting is selected, there may be cases in
w hich the listening mode is selected automatically to match a Dolby
Digital source signal depending on the com bination of listening
mode and source signal.
At
D.M ANUAL, if the audio reproduction stops in the middle due
to change in the input signals, etc. press the
LISTEN M ODE knob.
If the
INPUT M ODE key is pressed quickly, sound m ay not be
produced. Press the
INPUT M ODE key again.
INPUT SELECTOR
INPUT MODE
名称未設定-
8
