50
TROUBLESHOOTING GUIDE
(continued)
PROBLEM
POSSIBLE CAUSE
SOLUTION
15. Kneader cannot
be removed.
16. Bread sticks to pan/
difficult to shake out.
17. Breadmaker not
operating/Kneader not
moving.
18. Ingredients not mixed.
19. Burning odour noted
during operation.
20. Machine unplugged
by mistake or power
lost during use.
How can I save
the bread?.
21. EH appears on
display and machine
cannot be turned on.
22. E-L or E-S appears
in display and
machine cannot be
turned on.
• You must add water to bread pan and
allow kneader to soak before it can
be removed.
• Can happen over prolonged use.
• Breadmaker not switched on.
• Pan not correctly located.
• Delay timer selected.
• Wholemeal program selected
• Did not start bread maker.
• Forgot to put kneader in pan.
• Ingredients spilled inside oven.
• Pan leaks.
• Exceeding capacity of bread pan.
• Oven chamber too hot.
• Bread maker is malfunctioning.
E-L = temperature of unit too low.
E-S = temperature sensor error.
• If machine is in knead cycle, discard ingredients and start again.
• If machine is in rise cycle, remove dough from bread pan, shape and place in
greased 23 x 12.5cm/9 x 5 in. loaf tin, cover and allow to rise until doubled in size.
Bake in pre-heated conventional oven at 200ºc/400ºF/Gas mark 6 for 30-35
minutes or until golden brown.
• If machine is in bake cycle, preheat conventional oven to 200ºc/400ºF/Gas mark 6
and remove top rack. Carefully remove pan from machine and place on bottom
rack in oven. Bake until golden brown.
• Follow cleaning instructions after use.
You may need to twist kneader slightly
after soaking to loosen.
• Lightly wipe the inside of bread pan
with vegetable oil.
• Refer to “Service and customer care”
section (page 51).
• Check on/off switch is in the on position
(see page 4)
• Push pan down until it clicks securely
into place.
• Breadmaker will not start until the
countdown reaches the program start
time.
• 15-30 minutes delay at start of
program 4, 5, 6.
• After programming control panel, press
start button to turn bread maker on.
• Always make sure kneader is on shaft
in bottom of pan before adding
ingredients.
• Be careful not to spill ingredients when
adding to pan. Ingredients can burn on
heating unit and cause smoke.
• To obtain a replacement, contact
Customer Care on
023 9239 2333.
• Do not use more ingredients than
recommended in recipe and always
measure ingredients accurately
.
(see page 5)
• Unplug and allow to cool down for 30
minutes.
• See “Service and Customer care”
section.
PAN PROBLEMS
MACHINE MECHANICS
Summary of Contents for BM200 series
Page 1: ...Instructions Recipe Book BM200 series ...
Page 4: ...3 ...
Page 15: ...Recipes 11 ...
Page 56: ...Kenwood Ltd New Lane Havant Hampshire PO9 2NH www kenwood co uk 54037 2 ...