46
English
5.
Press the CURSOR UP/DOWN buttons to select
“Apply”, then press the OK button.
■
When selecting the Manual or the Dynamic
• Then the network test is automatically performed and
the result is displayed.
• Press the OK button to confirm the test result. Then the
network information will be displayed.
■
When selecting the Off
• The values for IP Address, Subnet Mask, Gateway,
Primary DNS and Secondary DNS are all cleared.
When selecting the Network Test
• Then the network test is automatically performed and
the result is displayed.
• Press the OK button to confirm the test result. Then the
network information will be displayed.
• For how to select the setting items and options, refer to “OSD Menu Settings” on page 40.
• Settings with* are the default.
■
Note :
• When listening in the STEREO mode on the unit’s BD player, you should set the speaker other than Front L and R to Off.
Setting items
Options
Speaker configuration
Set the speaker according to the
speaker configuration settings that
you set on this receiver.
(For details, refer to “When selecting
the SPEAKER CONFIGURATION” on
page 21.)
Front L
Center
Front R
Surround L
Surround R
Rear (Surround Back) L
Rear (Surround Back) R
Large*: Select this when connecting speakers
that can fully reproduce sounds below
crossover frequency.
Small: Select this when connecting speakers
that can not fully reproduce sounds below
crossover frequency.
Off: Select this when no speakers are connected.
Subwoofer
80*/100/120 Hz: Select the crossover frequency
to reproduce the sounds below
crossover frequency from the
subwoofer (or from the speakers
which are set to Large(when not
using a subwoofer)).
Off: Select this when no speakers are connected.
Test
Select the desired test tone to be heard when the test tone
function is activated.
• To select the desired setting item, press the CURSOR UP/
DOWN/LEFT/RIGHT buttons, then press the OK button.
Pink*/1 kHz Sine/White: Select the test tone to be
reproduced.
• When the test tone is selected, the test tone will
be heard from the speakers successively.
■
Note :
•
To cancel the test tone function, press the OK
button.
SETTING THE SPEAKER
BDR-A7_EN_CS3.indb 46
BDR-A7_EN_CS3.indb 46
11.3.10 6:59:42 PM
11.3.10 6:59:42 PM
