18
English
• The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most
situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to
be changed later.
1.
Turn the setup menu on.
2.
Select the desired menu using the CURSOR UP/DOWN buttons.
3.
When selecting the “SOUND PRMT” or the “SPK SET”, press the OK button to enter it’s setup menu.
• When “SPK SET” is selected, see “Setting the speaker
setup” on page 20.
• When “SOUND PRMT” is selected, see “Setting the sound
parameter” below.
SYSTEM SETUP
• “SOUND PRMT” will be shown.
• To turn the menu off, press this button again.
• When the RETURN is pressed on a sub-menu, it will returns
to the previous menu.
• Each time these buttons are pressed, the setup menu is
selected as follows :
“SOUND PRMT”
↔
“TONE”
↔
“SPK SET”
(Sound Parameter) (Speaker Setup)
• When “TONE” is selected, see “Setting the Tone” on page
23.
Setting the sound parameter
• You can adjust the different sound parameters for optimum surround effect.
• Settings with* are the default.
1.
Press the CURSOR UP/DOWN buttons to select the desired parameter.
■
Notes :
• “C.WIDTH”, “DIMEN” and “PNRM” can be selected only while listening in Dolby Pro Logic II Music or Dolby Pro Logic IIx
Music mode.
• “D.M.” and “DRC” settings are not valid when BD/DVD is selected as an input source.
SOUND PRMT
L.SYNC 0* / 0 ~ 9.0
D.M. CH1* / CH2 / CH1+2
DRC OFF* / MID / MAX
LFE 0 dB* / -10 / OFF
C.WIDTH 3* / 0 ~ 7
DIMEN 0* / -3 ~ +3
PNRM OFF* / ON
BDR-A7_EN_CS3.indb 18
BDR-A7_EN_CS3.indb 18
11.3.10 6:59:36 PM
11.3.10 6:59:36 PM
