Cleaning the Water Tank
Open the Upper Cover.
Remove the water tank.
Clean it under running
tap water and wipe dry.
Switch off the power supply.
Recommended Frequency for Filter/Membrane change
Sediment/Carbon
Once every year or earlier if it gets clogged
UF Membrane
Once every year or earlier if it gets clogged
Technical Specifications
7. Allow the filters to pre-soak in water for 2-3 minutes.
8. Connect the power supply.
9. Installation is complete.
7
Maintenance
To ensure that the purifier operates at its best, routine maintenance must be performed. The
frequency of maintenance will greatly depend upon the raw water quality and consumption of
purified water.
• Storage tank must be cleaned once in a week. (Refer Cleaning the Water tank Pg. 8)
• In the event of not using purifier for more than two days (while going on a holiday, tour etc.),
turn off the raw water supply and drain the storage tank
• Replace the sediment filter and carbon filter once in an year
• Replace the UF membrane once in a year
The replacement time of consumables such as filters and membrane is dependent on
the quality of raw water and water consumed.
Starting-up the Purifier
• Switch on the power supply
• Allow the storage tank to fill up to the
maximum level
• Switch off the power supply
• Open the upper cover. Lift and drain the
storage tank so as to remove the residual
dust particles initially present in the pipes
Note: The glowing red LED indicates the power is on. The glowing green LED
indicates the purification process is on.
Important Safety Instructions
• If the supply cord is damaged, it must be replaced by the original part in order to avoid hazard
• Children should be supervised to ensure that they do not play with the appliance
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety
8
Ideal for Tap/Municipal water supply
White
7 L
0.3 kg/cm
2
/10ºC
0.1 Micron
11W
Applications
Product Colour
Purification Production Rate
Body Material
Installation
Product Dimensions (mm)
Filter Cartridge
Purified Water Tank Capacity
Inlet Water Pressure/Temp (min)
Net Weight
UF Membrane Pore Size
UV Lamp Wattage
20L/hr.max. (Under standard testing condition)
ABS Food Grade Plastic
Wall-mounting/Counter-top
390 (L) x 285 (W) x 400 (H)
Sediment, Carbon Block Filter, UF & Post Alkaline
6.20 kg
4 kg/cm
2
/40ºC
Inlet Water Pressure/Temp (max)
11149
Product Code
Product
KENT MAXX ALKALINE
24V DC
Voltage Output of SMPS
5000 hrs. of operation
Life of UV Lamp
Water Purifier
Product Generic Name
Input Power Supply
Single Phase 140-250 V AC, 50-60 Hz.
Total Power Consumption
36 W
IP Number
IPX1
and storage tank
• Place the storage tank back and close the
upper cover
• Switch on the power supply
• Purifier is ready to use
