CHANGING TIMING BELT (Figure 1�)
Complete the operation for removing the motor. Then put the Hi-Neutral
Lo lever ( #15, Figure 9) in the Lo position, remove the draw bar
{#14, page.36)
(A, Figure
12)
and lower the spindle.
Remove screws
(#64, page 36)
(B) hodling the upper and lower housings
(#63, page 36)
together, including the two lo.wer· scr�ws (C) in speed
changer bracket just below the speed dial.
·
·
-· -----1-------'--
B--!
Figure 12. Removing Timing Belt
------c
A slight
blow under the speed changer bracket
(#5,-page 34)
may be
needed to separate the upper housing (D) from its base.
As the housings are being separated, the HTD belt ( E)
(#36, page 34)
D
still connects them, resisting the separating movement. The separation
can be assisted by gently pushing the belt off the large pulley ( #86, pa.ge
34)
as the upper
'
housing is being raised.
Remove the old belt and replace with a new belt.
-23-
Property of Kent Industrial USA
Do Not Reproduce
