ASSEMBLY INSTRUCTIONS
FOR MOUNTING'S K /SVK VARIDRIVE HEAD TO RAM ADAPTOR
Insert the four (4) tee bolts into the ram adaptor and position them to
match the bolt holes in the he.ad.
Slide the head onto the bolts, insert the spacers and washers 11nd secure
with the nuts.
Tighten all nuts to 30 ft. lbs. of torque, and then repeat to 75 ft. lbs.
CAUTION
IMPROPER TIGHTENING OF THESE CO\]LD
CAUSE
A CHOPPY QUILL MOVEMENT
LUBRICATION:
The useful life of the ..5Kl5VK _Head will be determined to a large extent by whether.
proper lubrication methods are followed. Carefully follow the lube plate recommenda•
tions and avoid substitutions.
OPERATING INSTRUCTIONS:
SPEED CHANGE HANDWHEEL ( 16, Figure 9):
DO NOT ath:mpt to change spindle RPM unless the motor is running.
Dial speeds will only be approximate. Belt wear will caus� a slight variation
in speeds from what is indicated on the dial.
When tightening or loosening the drawbar
(#
14,_page 36)
.
, it is necessary
to lock the spindle. To do this, use the spindle brake ( 3) which is located
on the
_
left side of the belt housing. turning it �it her right or left until it.
binds.
Make
sure the quill is raised
all
the way.
Drawbar
_
(#
14, page 36)_ ha·s 5/8"
-
I
-
I "right hand threa"d and should be
tightened with normal pressure us.ing wrench furnished
with
machine.
To loosen collet. back off draw bar and if collet does not open, given
.
top
of drawb:�r a slight· tap. Spindle has non-sticking taper and collet should
release readily.
- l-4--
Property of Kent Industrial USA
Do Not Reproduce
