The unit can be controlled by either the touch panel controls which are located on the lower right side of the front
glass or the remote control.
0DLQ3RZHU6ZLWFK
2SHUDWLQJZLWK7RXFK3DQHO
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
127((QVXUHWKHKRXVHFLUFXLWEUHDNHUVIRUWKHSRZHUVXSSO\DUHWXUQHGRQ,QWKHHYHQWRIDSRZHU
IDLOXUHWKHDSSOLDQFHZLOOORVHLWVPHPRU\IXQFWLRQDQGZLOOUHVHWWRIDFWRU\PRGHZKHQWKHSRZHU
UHWXUQV
To turn unit power on:
1. Plug in power cord. If hard wired, just turn on the power switch on the unit.
2. Verify the power is turned on when two ring tones are initiated.
2SHUDWLQJ,QVWUXFWLRQV
WHILE THE APPLIANCE IS OPERATING DO NOT REMOVE THE GLASS PANEL. THIS WILL CAUSE THE
REMOTE CONTROL TO DISFUNCTION.
:$51,1*
Page 1
5
08.19.20
3.
Press the “
” button multiple times to cycle through 4 different brightness levels and OFF for all the
4. Press the “ ”Multiple times to cycle through the ember bed colors of red, pink, snow white, cool blue, dark blue,
1.
2. Press the “
ember bed (E3) LEDs at the brightest level. Press again, the heater is in OFF status indicate "OF", goes off after
green, lake green, all-colors automatic circulation (EE) in 30 seconds and OFF (E0).
1
RWH
Press the “ ”button to set temperature level, press key for temperature setting, if room temperature is lower than
both the heating systems and the blower are OFF (indicate H0). Repeat circulation.
6
.
.
Press the
“
"to activate the timer. Press once for 30 minutes. Each additional press adds 1 hour to a maximum
of 8 hours.LED display shows 30-1H-2H-3H-4H-5H-6H-7H-8H-00
Indicate E1-E2-E3-E4-E5-E6-E7-EE-E0..
5
button to turn on/off the fireplace; If turn on (indicate "ON"), the Red, blue and yellow flame (F4),
”
5 seconds.
flames LED (Red, Yellow and Blue). Indicate (F4-F3-F2-F1-F0).
temperature setting, two groups of heating system will turns ON (indicate current temperature setting); press until
Celsius & Fahrenheit degree setting. Press and hold button for 3 seconds, interchange Celsius and Fahrenheit degree
C: H0-16-19-21-23-25-27-30. F: H0-61-66-70-73-77-80-86
Ensure steps 1-2 in the"Main Power Switch"procedure are first followed.
The touch panel buttons will glow when pressed. The light fades in 5 seconds after pressing.