28
Changing the Filter
Locating the Filters
Your refrigerator is equipped with water
filtering system. The water filter system filters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
The water filter is located at the top right
side of the fresh food compartment.
Ordering Replacement Filters
To order your replacement filters, please
visit the dealer where you purchased your
refrigerator. Sears recommends that you
order extra filters when you first install your
refrigerator, and that you replace your filters
at least once every six months.
Here is the product number to request when
ordering:
Kenmorepure!
TM
Water Filter
Part #
9919
Replacing the Water Filter
In general, you should change the water
filter every six months to ensure the highest
possible water quality.
Water Filter Status
on
the user interface prompts you to replace the
filter after a standard amount of water (200
gallons/757 liters for
Kenmorepure!
TM
) has
flowed through the system.
If your refrigerator has not been used for a
period of time (during moving for example),
change the filter before reinstalling the
refrigerator.
Filter Cartridge
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system. Systems certified for cyst
reduction may be used on disinfected waters
that may contain filterable cysts.
Test & Certification Results:
• Rated Capacity - 200 gallons/757 liters
for
Kenmorepure!
TM
ice and water filter
•
Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To Replace your Kenmorepure!
TM
Water Filter:
It is not necessary to turn the water supply
off to change the filter. Be ready to wipe up
any small amounts of water released during
the filter replacement.
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the end/
face of the filter.
3. Slide the old water filter cartridge
straight out of the housing and discard
it.
4. Unpackage the new filter cartridge.
Using the alignment guide, slide it
gently into the filter housing until it stops
against the snap-in connector at the
back of the housing.
5. Push firmly until the cartridge snaps
into place (you should hear a click
as the cartridge engages the snap-in
connector).
The
Kenmorepure!
TM
ice and water
filter system is tested and certified
to NSF/ANSI Standards 42 and
53 for the reduction of claims
specified on the performance data
sheet.
More about your Advanced Water Filter
NOTE
When ordering your replacement filter,
please reorder the same filter type that is
currently in your refrigerator.