21
Automatic Ice Maker - Freezer
Operation & Care of the Freezer Ice
Maker (select models)
After the refrigerator is installed properly, the
ice maker can produce ice within 24 hours. It
can completely fill the ice bin in about three
days.
When using the ice maker for the first
time and in order for the ice maker to
work properly, it is necessary to clear air
from water filter tubing. Once ice maker
begins making ice, allow the bucket to fill
completely, then discard the first TWO FULL
buckets of ice. It will take at least two days
to completely fill the bucket on regular ice
making mode or 1
½
days on fast ice mode.
The ice maker produces approximately four
pounds of ice every 24 hours depending on
usage conditions.
Turning the Ice Maker On and Off
Ice
production
is controlled
by lifting/
lowering the
ice maker’s
wire signal
arm. To gain
access to the
ice maker,
pull the
freezer drawer out. Lift the wire signal arm
to turn the ice maker OFF and lower the wire
signal arm to turn it ON.
Cleaning the Ice Maker
Clean the ice maker and ice bin at regular
intervals, especially prior to vacation or
moving.
1. Turn off the ice maker.
2. Remove the ice bin.
3. Empty and carefully clean the ice bin
with mild detergent. Do not use harsh or
abrasive cleaners. Rinse with clean water.
4. Allow the ice bin to dry completely
before replacing in the freezer.
5. Replace the ice bin. Turn the ice maker on.
Remove and empty the ice bin if:
• An extended power failure (one hour or
longer) causes ice cubes in the ice bin to
melt and freeze together.
Remove the ice bin and shake to loosen the
cubes or clean as explained above.
Ice maker tips
• If your refrigerator is not connected to a
water supply or the water supply is turned
off, turn off the ice maker by lifting wire
signal arm.
• The following sounds are normal when the
ice maker is operating:
Wire
Signal Arm
ON
OFF
IMPORTANT
Your ice maker is turned on at the factory
so it can work as soon as you install your
refrigerator. If you cannot connect a water
supply, lift the ice maker’s wire signal arm
to turn it off. Otherwise, the ice maker’s fill
valve may make a loud chattering noise
when it attempts to operate without water.
CAUTION
If the water supply to your refrigerator is
softened, be sure the softener is properly
maintained. Chemicals from a water
softener can damage the ice maker.
CAUTION
NEVER use an ice pick or similar sharp
instrument to break up the ice. This could
damage the ice bin.
To loosen stuck ice, use warm water.
Before replacing the ice bin, make sure it
is completely dry.
- Motor running
- Ice dropping into ice bin
- Water valve opening or closing
- Running water
• Ice cubes stored too long may develop an odd
flavor. Empty the ice bin as explained below.
Quick Ice Function
Your refrigerator is equipped with a Quick
Ice Function, that increases ice production.
This function terminates automatically.
Quick Freeze Function
Your refrigerator is equipped with a Quick
Freeze Function that activates a faster rate
for freezing food.