REFRIGERATOR INSTALLATION
15
Replacing the Left Door
Install the left refrigerator door after the right door is
installed.
1
Make sure that the plastic sleeve is inserted in the
bottom of the door. Install the refrigerator door onto
the middle hinge.
Fit the hinge (1) over the hinge lever latch and slot it
into place. Rotate the lever clockwise (2) and fasten
the hinge.
Hinge Lever Latch
3
Connect all the wire harnesses.
Push the water supply tube into the hole on the top
case and pull it through the backplate.
5
Hold the water supply connection and gently push in
the collet (1) to connect the water supply line (2) as
shown. Insert the tube at least 5/8 inch (15 mm) into
the connector. Insert the clip on the joint to fasten the
tube in place.
Collet
Place the cover (1) in place. Insert and tighten the
cover screw (2).
NOTE
Disassembling/Assembling the Water Lines
Collet
Tube
Insert line
Clip
(Correct)
v
Gently press the collet and insert the tube until only
one line shows on the tube.
(Correct)
(Incorrect)
